The Twist Banner Stand FlexiLink Kit allows you to create a flexible 'hinge' in between any pair of Twist 2 Banner Stands or Twist 2 AV Banner Stands. The kit includes the printed panel which has a width of 500mm along with the magnetic connector bars and linking pins that are needed to secure the panel in between the stands that flank it.
Twist Flexilink Kits allow you to create curves in walls of connected Twist Banner Stands. The panel is flexible up to an angle of 180 degrees so as well as creating curves and corners in walls of stands, Flexilink panels can also be used to create a rounded shape on the end of a row of stands too.
Where Can I Use A Twist Flexilink Kit
Twist Flexilink Panels form a bridge between Twist 2 Banner Stands or Twist 2 AV Stands. It is not possible to connect more than one Flexilink Panel. If you want to create a wavy wall, it is possible but you must alternate between a Twist 2 Banner and a Twist Flexilink Panel.
Twist Banner Stands are used to trap the Flexilink panel between them
The Twist Flexilink Panel acts like a hinge between the two Twist Banner Stands
How Does The Flexilink Panel Join Between The Twist 2 Banner Stands
The Twist Flexilink panel slots into the top and bottom rails that are attached to the graphics on the Twist Banner stand. Both the Twist Banner Stand panels and the Flexilink panel are fitted with magnetic tape that runs vertically on each side edge. The Flexilink Kit includes magnetic bars than bridge the magnetic tape between the two panels to keep the join secure.
Twist Banner Stand Flexilink Panels - What Included
500mm wide printed graphic panel fitted with Twist2 flexible fixing rails on top and bottom - The printed panel can be produced in a height of 2000mm, 2250mm or 2700mm (ensure to order the panel at the same height as is used on the Twist 2 Banner Stands that you want to connect it to.
Magnetic tape (pre-applied to vertical side edges of the panel)
Enough magnetic fixing bars to connect the panel between two Twist2 or Twist 2 AV Banner Stands
